您好, 歡迎來到化工儀器網
ASTM D5019測試標準
本頁面標準信息均來源于網絡收集，或由參與標準制定的供應商提供，只作為參考使用，為確保測試結果的準確性、節省您的時間，如需ASTM D5019標準詳細信息或ASTM D5019具體測試方法，歡迎與我們技術人員聯系或給我們留言，我們將為您相關的技術支持。
ASTM D5019標準介紹
ASTM D5019是用于單層屋頂薄膜的增強CSM板(氯磺化聚乙烯)的標準規范：
本規范規定了擬用于單層屋頂薄膜的、用氯磺化聚乙烯(CSM)制造的增強非硫化聚合物板空氣曝露測試程序。
ASTM D5019英文簡介
1. Scope
1.1 This specification covers reinforced non-vulcanized polymeric sheet made from chlorosulfonated polyethylene (CSM) and poly-isobutylene (PIB) intended for use as a single-ply roof membrane exposed to the weather. The sheet shall be reinforced with fiber or fabric.
1.1.1 The polymers used in these sheets have thermoplastic characteristics at time of installation. The chlorosulfonated polyethylene will vulcanize in place under ambient conditions on a roof.
1.2 The tests and property limits used to characterize these sheets are minimum values specific for each classification.
1.2.1 In-place roof systems design criteria such as fire resistance, field seaming strength, impact/puncture resistance, material compatibility, and uplift resistance, among others, are factors that must be considered, but are beyond the scope of this specification.
1.3 The following precautionary caveat pertains to the test methods portion only, Section 8, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents
ASTM Standards
D412 Test Methods for Vulcanized Rubber and Thermoplastic Elastomers--Tension
D413 Test Methods for Rubber Property--Adhesion to Flexible Substrate
D471 Test Method for Rubber Property--Effect of Liquids
D518 Test Method for Rubber Deterioration--Surface Cracking
D751 Test Methods for Coated Fabrics
D1004 Test Method for Tear Resistance (Graves Tear) of Plastic Film and Sheeting
D1149 Test Methods for Rubber Deterioration--Cracking in an Ozone Controlled Environment
D1204 Test Method for Linear Dimensional Changes of Nonrigid Thermoplastic Sheeting or Film at Elevated Temperature
D2136 Test Method for Coated Fabrics--Low-Temperature Bend Test
G151 Practice for Exposing Nonmetallic Materials in Accelerated Test Devices that Use Laboratory Light Sources
G155 Practice for Operating Xenon Arc Light Apparatus for Exposure of Non-Metallic Materials
▼ASTM D5019第三方檢測機構
以上標準信息來自互聯網搜索整理，如需了解完整的ASTM D5019的信息或ASTM D5019標準解讀，歡迎詳詢。